For general info about OpenFOAM see the unofficial wiki, the community forum or (note the.Youtube presentation: Verification and assessment of an open source solver for the filling stage of the injection moulding process.The cooling rate dependence of the specific volume in amorphous plastic injection molding - see the fork of this code. Verification and Validation of openInjMoldSim, an Open-Source Solver to Model the Filling Stage of Thermoplastic Injection Molding. Modeling Injection Molding of High-Density Polyethylene with Crystallization in Open-Source Software - see the fork. Specific heat and thermal conductivity may depend on temperature and pressure (tabular form).Compressible, non-isothermal, laminar cavity flow.Then run paraFoam in the case directory to view the results. AllRun in the dogbone directory to run the example simulation. To run the dogbone case, set the numberOfSubdomains in the decomposeParDict according to Allwmake in the solver directory to compile the code. It is a modification of the compressibleInterFoam solver distributed with OpenFOAM.Ĭurrently, the simulation is prohibitively inconvenient for typical industrial use but it can be helpful in research because it can be customized.Īn OpenFOAM 7 installation is required to run the code. This is an OpenFOAM solver for simulation of injection molding filling, packing and cooling stages.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |